motherboard with raid controller

[kzorba at otenet.gr]

At Fri, 13 Jun 2003 10:19:44 +0300,
Christos Ricudis wrote:
> 
> On Thu, 12 Jun 2003 20:39:24 +0300
> Giannis Stoilis <giannis at stoilis.gr> wrote:
> 
> > Sobara twra, den exw dei pou8ena ENA raid me 8 diskous.
> > Prin kanena xrono esthsa ena SAN me trianta hotplug compaq 18GB SCSI 
> > diskous(nai, kosthse parapanw apo ton mis8o mou arketwn xronwn). H 
> > entolh pou hr8e apo thn etaireia software htan na ftiaksoume POLLA mikra 
> > raid5 me hot-spares.
> 
> Kai poly swsta. 
> 
> Ayto poy den gnwrizw einai : Se periptwsh poy kaneis striping kai xtyphsei 
> ena block se kapoio disko, xaneis mono to block H oloklhro to stripe? Ayto
> endexetai na einai kai implementation-dependent. Se ka8e periptwsh, to raid5
> einai aparaithto, kai an yparxei arketa megalo portofoli, kai ta hot spares. 
> 
> -- 
> Christos Ricudis				ricudis at itc.auth.gr
> Systems Administrator				+30-2310-998305
> IT Support Center
> Aristotles University of Thessaloniki, GREECE
> 
> -- 
> linux-greek-users mailing list -- http://lists.hellug.gr


Apo to linux software raid howto gia to raid-0:

"You have two or more devices, of approximately the same size, and you
want to combine their storage capacity and also combine their
performance by accessing them in parallel.  
...
Like in Linear mode, spare disks are not supported here either. RAID-0
has no redundancy, so when a disk dies, the array goes with it. "


======================================================
  Kostas Zorbadelos
  Otenet IT Department | BSO Team
  
  Out there in the darkness, out there in the night
  out there in the starlight, one soul burns brighter
  than a thousand suns.